I am using allegro 16.5. unable to generate nc drill file to mechanical pin. After generating drill, the viewlog file shows below messages
Tool Num Size +/- Tolerance Plating Quantity
T20 1. 20.0000 0.0000/ 0.0000 PLATED 399
T28 2. 28.0000 0.0000/ 0.0000 PLATED 78
T40 3. 40.0000 0.0000/ 0.0000 PLATED 91
4. 138.0000 0.0000/ 0.0000 PLATED 0 ---- Can't find toolcode in nc_tools.txt
WARNING: Some toolcodes not found in 'nc_tools.txt' file.
Any one give the solution for this.
Thanks in advance
select the mechanical symbol check drill has assigned or not by using following ways tool-->padstack-->modified design padstack
In reply to kabalee:
Drill has assigned.
the errors is
How to edit nc_tools.txt file
In reply to Shivainna:
please open it in notepad or else post the snapshot for board file and warning
Manufacturer-->Nc parameter---->select ASCII code, format must be 2:3
Remaining plated drills are able to generate.
problems only in non electrical or mechanical pins
please post that mechanical pin padstack layer and parameter