In our present board while routing ground (GND) net, the tool getting slow and taking time to route every segment. But for other nets with VCC it working fine. There is no properties attached to the GND net. If anyone faced the same, please help to solve the issue.
Using Allegro PCB Designer v16.6
Close the schematic if it is open to prevent cross-probing, there is a Capture user preference to disable cross-probing global nets.
If the schematic is not open, set a value for the Voltage property for the net.
In reply to oldmouldy:
Thanks for your solution. After setting a Voltage property the problem has solved and it working smoothly.
In reply to C Shiva:
You are right i think. Because if i run the same board file in another system with older version of tool v16.01 without any property, it works fine without any lagging.