When I run DRC. I receive below message at the end of report file, although I checked the whole design completely:
Checking Misleading Tap connectionERROR(ORCAP-2207): Check Bus width mismatchChecking Physical Rules
I googled and found out this bug has been fixed in Capture16.6 QIR. What should I do now? Can I safely ignore this message or there is still something wrong with my design that I should correct it? Where can I find and install thehotfix for it?
I would appreciate any help on this issue
You might be able to ignore this message but you need to understand why you are getting it. This is likely caused by a bus that has a wire tapped into it that it outside the range of the bus or does not have the root bus name assigned to it.
In reply to oldmouldy:
Unfortunately, it didn't provide more information regarding that message. How can I find and fix the issue when I don't know where to look for it?
In reply to Hossein1357:
You have a DRC error, so you will have a DRC marker in the design for it. Select the DSN file entry in th eProject Manager window and then Edit>Browse>DRC Markers, then double click on the DRC entry to be take to the DRC Marker location in the schematic.
I followed your instructions and did not see any entries the page was completely clear. Can I now ignor this error message?!.. As I mentioned before I have seen such message in the list of fixed bugs and issues. Here is the title of document:
OrCAD Capture: What’s New in Release 16.6
Product Version 16.6October 2012Documented Last Updated on: January 20, 2014