I'm new to CST microwave studio. Just finish constructed a structure of
an L-probe patch antenna (from IEEE paper) and just run the simulation
by transient time solver, the curve of the return loss(S11) against
frequency that i get is different from what showing on the IEEE paper,
so is it the boundary condition setting will affect the simulation
results? And actually what is the function of setting the boundary
During the simulation, a warning message "some PEC material is touching
the boundary" was show. After change the boundary condition setting to
"open(add space)" then the warning will eliminate when run again the
simulation. But the s11 curve still different from the "actual" results.
Anybody can help?
Any comments will be appreciate.