I have several previously submitted (and even tested) and successfully DRC'ed/LVS'ed designs of some amplifiers etc. Now I want to perform LVS again since I want to start another design based on old one, and suddenly LVS exists with these errors:
*ERROR* cell 'ind' is not defined.*ERROR* cell 'pcdcap' is not defined.*ERROR* cell 'bondpad' is not defined.I have no idea what could go wrong? Same layout was LVS'ed nicely before with inductors and with above mentioned devices.Any ideas what exactly could break suddenly?
Assuming that you're using Assura LVS (from previous posts), are you:
Those are just the first questions that come to mind - it's hard to be sure without knowing a bit of context.
In reply to Andrew Beckett:
In reply to Kabal:
Can you check if those cells are missing from the CDL netlist? Are the instances there but no subckt definition?
Andrew, I checked, those cells are inside the CDL netlist. I am attaching the final exported from schematics netlist for LVS.By the way, I noticed that there is already update available for my kit from foundry, I updated to the latest version of the kit, then I pulled up my basic inverter, exported its netlist, and DRC'ed and LVS'ed its layout, all worked! No errors!But now, I again go to some template frame, which has bondpads and some esd cells/clamps. And again I get errors saying bondpad not defined! It does not make any sense!Here is the output of LVS when it quits with error: Reading schematic network
inputting netlist /media/cadence/runs/schematic/TOP_frame_template2/TOP_frame_template2.netlist.lvs
*WARNING* *.EQUATION is not supported
*WARNING* *.MEGA is not supported
*WARNING* *.PIN is not supported
*WARNING* The capability to discard or ignore devices is not available
Therefore all devices were included in the output
Even though no *.BIPOLAR command was found
Reading layout network
inputting network ./runs/LVS/TOP_frame_template2/TOP_frame_template2.ldb
*ERROR* cell 'pcdcap' is not defined.
*ERROR* cell 'bondpad' is not defined.
*WARNING* /home/soft/cadence/assura41/tools/assura/bin/nvn exit with bad status
*WARNING* Status 256
*WARNING* Assura execution terminated
*WARNING* An error occurred during Nvn PreExtraction.
LVS preprocessing requires a successful run of Nvn.
Assura will now terminate.
Alright, it broke because the subcircuit.cdl file which had description of those cells was not included during netlist export operation (it just suddenly disappeared from the menu). The thing is, this line with path to that file was forever in that menu, and I just didn't notice its absence at the beginning.
Now it works.