Hi all! I am wondering, where I can define the DEFAULT annotation setup for components in my schematics (in IC616)? For instance, for displaying the operating point parameters after a DC analysis I always have to change the annotation settings for my active devices through the View->Annotations-Setup options. It is time consuming having to do the same for each new schematic, so I would like to change the default annotation options for these devices so that they remain like these:
Parameter:cdsParam(1): DC Operating Point - id
Parameter:cdsParam(2): DC Operating Point - gm
Parameter:cdsParam(3): DC Operating Point - vds
Parameter:cdsParam(4): DC Operating Point - vdsat
Parameter:cdsParam(5): DC Operating Point - region
Thanks in advance for any help on how to achieve this.Cheers,Jorge
Please contact customer support for this issue.
In reply to Andrew Beckett:
Hi Andrew! Thanks for your suggestion, I have channeled my doubt through customer support (case 45570335).Regards,Jorge.
In reply to jorgeluislagos:
OK, problem solved! It was just a matter of editing these fields in the component's CDF settings. Thanks for the support! Cheers,Jorge.
In reply to Chrisss: