I am using AMS to simulate the top level of a chip. I am using 5.1 version of the tools. Currently I am launching AMS using ADE and running in interactive mode(ie with simvision). I would like to be able to run for some amount of time and then pause the simulation. After pausing, I would like to be able to save additional nodes, or create forces for nodes. I do not want to change any analog parameters. From looking through the documentation, it seems to say that this cannot be done when using the analog solver and old parser. I have tried to do this with my setup, and I have not been succesful. My question is "Is there a method to run AMS in version 5.1 that would allow me to do something like this. I want to be able to change what nodes are being saved, and what digital nodes are being forced."