Here's what I'm trying to accomplish. Any help will be super :
I want to plot all signals from a bus. The easiest way to accomplish this is to (1) go to ADE > Results > Direct Plot > Transient Signal
Now, you (2) click on the bus and a new dialog pops up asking you to select bits, you can (3) click Select All and then (4) click Ok. Then, you can (5) go to the Schematic and hit ESC and all signals will be plotted (AWV). I have a bindkey to do (1). But, I still have to do (3), (4) and (5).
How can I define a procedure that effectively does :
sevDirectPlot(session 'asiiPlotTranSignalCB) ; (1)
; let user select the bus (2)
_astiSelectAllIteratedCB ; (3)
; (4) and (5)
Any help would be super.
; Bind key for ResultsàDirect PlotàTransient signals
;Function for plotting buses
; Call the esc function earlier ,this is done
because after we ok the form this function does not work
; So we call it earlier
; Set context to the UI which
shows bus signals
;Select all members of the bus
; Ok the form after selection
;Function ends here
; Bind key
to call the plot function
Run simulation .
After simulation is
complete, click on the schematic window and press F10
This will enable the
cursor and select the desired bus to be plotted.
Once you select the
bus it will bring the UI for selecting the bits to be plotted.
Just select the
schematic window and press F11 key. This will plot all the bits of the bus.