Is it possible to setup the Reference designator assignment so to add prefixes?
I will have a multi-page design some of this pages will make a block of the system. And I want that Resistors from lets say page 1 to 6 get a prefix on its reference designation like RA1, RA2. . . RA345, then from pages 7 to 10 RB1, RB2 . . .RB245 etc. I don't want to use hierarchical design at the moment.
Is this possible?
On the schematic side just change the ref designations to what you want on the fly. On the board side- make a resistor part in your library (per your example) with a REF prefix with an asterisk (*) only. By the way, all your parts can have asterisks. That's because during the net list process your design will always suck up the REF's per your schematic. This is true for values, part numbers and anything else you you would like to pass to layout. Give that a shot