Google FeedBurner is phasing out its RSS-to-email subscription service. While we are currently working on the implementation of a new system, you may experience an interruption in your email subscription service.
Please stay tuned for further communications.
I am just beginner for Packaging Design I don't know well about Etch back
I used the "Etch Back" function to connect BGA pin to pin
but I faced the External DRC error after checking by "Plating Bar Check"
but the error message is quite vague for me
despite I connect using Etch Bar, the message said there is not connected by plating bar
How can I solve this problem..?