I'm using OrCAD 16.2 with PSpice.
When I try to use PSpice, it always pop-up an error message and says "Server Busy". I had 2 choices "Switch To" and "Retry". Neither of them worked. Any clue on this?Thanks.
I would recommend that you install 16.3.
A number of issues that could cause this situation have been solved in 16.3.
If you run Windows Vista (or Windows 7 - although not supported yet) - right click on setup.exe and select run as administrator to get the sw installed properly.
Also after installation - use right click on shortcuts and run as administrator (can be set as default on Windows 7 under the properties section)