Has anyone ever had an instance where a poured shape did not update around different-net vias, resulting in a short? The tool is Allegro 16.2.
Could be you don't have dynamic shapes set to smooth?
They're set to smooth; it's just two vias that are shorting.
Is there any properties attached to the vias that are shorting to the shape?
There are two different properties attached to the VIA that would cause this to occur.
DYN_CLEARANCE_TYPE = NO_VOID
NET_SHORT = <Net Name of Shape>:<Net Name of Via>
Info the VIA, not the NET, using Display Element and check for the existence of one of the Properties above. Also I would try to draw another shape of the same net on a different layer to see if the same different-net vias short again to rule out it being a layer or shape specific issue.
Hope this helps,Mike CatrambonePlexus Engineering Solutions
Thanks for the information, but there are no properties attached to the vias. The same via is used all over the board, but was just the two vias that the shape didjn't update around.