In the attcahed picture I have some void areas in the gnd plane that I can not get rid of. I have tried turning all colors on to see if there was somthing hiding there, but nothing shows up. Screen redraws and closing / re-opening board file have no effect.
What are these mysterious areas and how do I get rid of them?
Once again OM, you are right on target. I didn't think of that. The previous part had 2mm lead spacing and there were islands between the pins that I deleted. This must have been left over artifacts from that island removal.
I have to say though, you'd think the software would take care of them. For that matter, you'd think it wouldn't leave islands in the first place.
Have a great weekend!