A newbie here. I have used Orcad for a very little while, so a learning curve. I placed a transformer on the page, and want to remove the "pin numbers' from the symbol. How do I go about this? I have done the right click on the lead, then edit properties, hihlighted the "name" colum and get lost after that. I have tried to find the answer in the help menu, but....
Thanks for your reply. Will look at how to do this.
Perhapds I should say at this stage that I'm using
Capture CIS Lite Edition 16.3-p008 (v16-3-85H) 11/17/2009
Copyright 1995-2009 Cadence Design Systems, Inc.All rights reserved.
I haven't been able to find anything in the help section regarding layers
Thanks, Dave. OK, can anyone who knows Capture help me, please. I'm only wanting to draw the circuit diagram, and not proceed to the layout. Because of this, I don't need the pin numbers showing for the transformer and/or the pilot lamp. I found a bridge rectifier without the pin numbers, and that appealed to me. So, where to now? Any helpers out there?!