I'm stuck with a problem now for a couple of days. Basically I need to design the following footprint:
The red lines should be on TOP layer, the blue ones on the INNER layer. Associated copper should be connected by vias or pins (green).
As a workaround I drew all the lines as "dead" copper and added the vias as mechanical pins but that ended up in a DRC mayhem later in the design. Is there any elegant solution to design such a footprint?
Any help would be very welcome.
Sorry for the late answer... what do you mean by offset drill? I think I didn't use that function so far.
The components is going to be a switch by applying a carbon print on the red TOP-lines which will be shortcut by a rubber button. The button has a conductive surface on the bottom.
Any further ideas anyone?
Thanks and Greetings,