I normally don't autoroute anything, but I'd like to try it on a board I'm working on. Problem is this board is 8 layers and my seat is limited to 6 layers. I'm thinking I can remove the layers where I have the power and gnd planes from the stack up and disable those nets in CM. Then add the layers back in after the routing has been done.
If this will work, how do I "lock" any existing traces I have routed to prevent the autorouter from moving them?
Mstrghettorigg said:I feel like I could never get autorouter to do anything I wanted it to do.
I feel like I could never get autorouter to do anything I wanted it to do.
My sentiments exactly.
There is one area on this board that I want to see if it can save me some time. I have most of the critical stuff in so I figured I'd give it a shot at the rest of the signals. We'll see..........