ORCAD 16.0.0 b001
At some point in my layout of a board I lost my Drill Chart data.
Upon subsequent edits and mods the drill chart shows only the newly added drills.
My DTS and TAP files are OK.
Is there any way to restore the drill chart?
I tried the MAX-MIN-MAX but to no avail.
Maybe because there are a few of the last added drills showing in the table or maybe because I don't know what I'm doing!
I think it's time to upgrade from Layout. I'm sick of swearing at layout, corrupted max files, etc.
I used Update90.exe but still no luck!
When I use GC-Prevue to check my gerber files each physical layer is interpreted as 3 data layers instead of the usual one.
Data layers 1 & 2 don't seem to have any visible data, layer 3 seems to define the whole layer.
Anyway GC-Prevue draws the board correctly.
I bit the bullet (counted holes/sizes from the drill file) to get Ver 2.1 out to the board manufacturer.
This problem has been around since Ver 1.0 and the boards have been produced OK so I can live with it.
Thanks for your help.