I am facing problem in a dense board. me and my collegue working on a same board, he finishes routing on his part. When I merged both files there were unrouted nets showing on his part. I try drive connectivity and db doctor but problem is still there. kindly help me in this regards.
Make sure your both in the same units with the same accuracy. Also when you merge make sure you use the excat same origin (0,0). Have you verified his design was connected?
Maybe he did not have snap to connect point or pins enabled in the find filter. Verify with a a report or show element.
EMA Design Automation
Thanks for your reply.
Actually I was using origin (0,0) for copying and the units of both boards]
were also same.
I was trying hard to get the problem solve.
One thing worked for me. I moved all the traces and vias outside the board and then moved them back and my problem solved.
Thanks for your kind intrest.