i am designing a microcontroller 2 sided board in Allegro 16.5, after routing all the components, i want to apply the Copper Poring(Power Ground) on both sides.
I can do it easily but the problem is, after copper pouring when I use "Gloss" option , the blank spaces which was there between tracks and Copper pour vanishes and goes away. It looks like all the tracks got merged with the copper pour. This only happens when i use Gloss and i can not revert it back.
Is this only for the view or is it realy a problem? I am not able to figure it out.
a help will be appreciated.
After running Gloss the dynamic shapes become out of date and need to updated. Go into Display > Status... and under the Shapes section change the Dynamic fill mode to Smooth and click the Update to Smooth button. All should be well again.
Hope this helps,Mike Catrambone