I am interested on to put the 4 layers boards in layout.Since in the layout via definitions are there. Then how can i put my four layer board with Layout.
How to put the vias in the ground and plane layer? Provide me an better solution for this.
Whether any guide is there to learn the multilayer board.
First go setup-->cross section and then add layer.by default via will be assign.
Thanks for your reply. Then i had go to options---> stack up settings, how can i insert the define the layer by layer and how to give the drill size of it.
(For e.g):- For Double layer, In case i am using via 1 means drill size will be 0.60. So after that i am using 4 layer board means i use th via 2 means how can i insert it and provide the drill size.
Can u provide me an better tutorial link for the 4 layer board design. In my concern they use to use 4 layer board, me was searching the better tuto for the 4 layer design.