Has anything changed in the last few years? With a large number of cline segs running parallel to each other, is there a way to distribute traces between and outer set of cline segs? The feature below has a similar functionality but doesn't allow the width of the "channel" to be specified by selecting the outer set of cline segs.
One example where this is important would be to reduce crosstalk amongst traces. I may route a board and, when I'm done, realize there is more space available than I thought. Physical separation between traces is important, so I'd like to spread out the traces and consume all the board area to separate the traces. In this case, I could slide one cline seg and then spread out all segs between the outer pair. Has this capability been added since this post was created, or is there another way?