When I run DRC. I receive below message at the end of report file, although I checked the whole design completely:
Checking Misleading Tap connectionERROR(ORCAP-2207): Check Bus width mismatchChecking Physical Rules
I googled and found out this bug has been fixed in Capture16.6 QIR. What should I do now? Can I safely ignore this message or there is still something wrong with my design that I should correct it? Where can I find and install thehotfix for it?
I would appreciate any help on this issue
You might be able to ignore this message but you need to understand why you are getting it. This is likely caused by a bus that has a wire tapped into it that it outside the range of the bus or does not have the root bus name assigned to it.
Unfortunately, it didn't provide more information regarding that message. How can I find and fix the issue when I don't know where to look for it?
You have a DRC error, so you will have a DRC marker in the design for it. Select the DSN file entry in th eProject Manager window and then Edit>Browse>DRC Markers, then double click on the DRC entry to be take to the DRC Marker location in the schematic.
I followed your instructions and did not see any entries the page was completely clear. Can I now ignor this error message?!.. As I mentioned before I have seen such message in the list of fixed bugs and issues. Here is the title of document:
OrCAD Capture: What’s New in Release 16.6
Product Version 16.6October 2012Documented Last Updated on: January 20, 2014