The following behavior is observed when manipulating the Place/Component window in an open project:
Is this a known issue?
Update to this issue:
In step (3), using the tab of the Component window to drag it back to the workspace will allow redocking, so this step is resolved.
That leaves the issue of dragging the Component window out of the project space and closing in, and then not being able to reopen it using Place/Component as unresolved.
2nd update to this issue:
With the Component window undocked from the OrCAD workspace and displaying in another monitor, if only the "x" in the "Unified CIS" tab is used to close the window, it WILL reopen in the OrCAD workspace when selecting Place/Component. This resolves the overall issue except for the case when the Component window's top-right "x" is used to close the window, in which case, if this was done with that window outside of the workspace, it will not reopen during the current OrCAD session.
Yes I too have faced this issue. There is issue in docking & redocking of component tab.
Thank you for the feedback and concurrence.