importing Netlist to allegro

You may want to read the documentation for 'netrev' in $CDSROOT/share/pcb/batchhelp/netrev.txt

Then try running netrev from a command line using the -o option with either the -1 or -2 additional option flags

thank you for your replay. I find this file.If i use command line, the Constraint Difference Report may not be made.but error is that Schematic supports creating XNets for passive devices and for devices having XNET_PINS properties but the Layout will create XNets only for devices having XNET_PINS properties. Change setting in Layout or Schematic, re-generate files, and re-run the flow.

Open the .cpm file in notepad & add the below lines & then generate netlist. When imported there shouldn't be any issue.

START_CONSTRAINT_MGR
AUTO_XNETS_USING_DML ‘OFF’
AUTO_XNETS_USING_GATES ‘OFF’
END_CONSTRAINT_MGR

Open the .cpm file in notepad & add the below lines & then generate netlist. When imported there shouldn't be any issue.

START_CONSTRAINT_MGR
AUTO_XNETS_USING_DML ‘OFF’
AUTO_XNETS_USING_GATES ‘OFF’
END_CONSTRAINT_MGR

@Schulz Jordan

I have added the macro command in the CPM file, but the same error happened.

this error happened when I Iset the pin pair constraints in the constraint manager. but the pin pair setting can not be saved in the constraint manager.