I have a little problemwith a particular dynamic shape. I have a dynamic shape and is it assigned a net and still it is separated. What is the problem? Why don't they connect if they are on the same net?
Is it possible your same net - net spacing settings are affecting this? Check your constraints for same net to net spacings.
In reply to budnoel:
Didn't work....any ideeas?
In reply to Szabolcs88:
Any chance you can post a screen shot of what you're looking at?
I hope this helps....
The link doesn't work - Can you please attach the image to the forum posting using the Options tab when replying to the message.
In reply to mcatramb91:
Here is it. Thank you for the tip on how to put pictures here.
Do you have an anti copper line that is not displayed in that area? It will still affect the pour but you just wont see it.
In reply to tmd63:
Did you discover what was causing this problem? Just curious.
Two things to check.
Is there a Route Keepout defined in that area which is causing the separation (turn all Route Keepout Layers)
Is there a shape void defined that is causing the separation. (Shape > Manual Void.... > Delete, select the shape and window over the separation to delete the void if it exists) Also running Delete Islands (Shape > Delete Islands) would create these types of shape voids if at one point you had two traces that ran thru the area to form an island in the shape.
Hope this help,Mike CatrambonePlexus Engineering Solutions
Go to Display - Color Visibility and turn on the Bound for the specific layer that has the issue. This is a good way to view the outer boundary of the shapes including any voids / islands that have been deleted.
In reply to steve:
After many aggonizing hours i have found the problem....Sadly it was an ORCAD PCB EDITOR bug of somekind..... i have opened it at work and there everything was ok...thank you for the tips