I have a problem while doing the routing. Attched the snap shot. If i reroute the net problem sloved. is there any easy way to slove this problem. I am using allegro 16.3
In reply to Pawandeep:
The reason you get these Connect Point Markers (setup - Design Parameters - Display tab for size) is because some part of the net is part of a Replciate Module and the connect point marker shows where this join is. You can either hover of the module and RMB - Disband Group or ignore it (or reduce the size). It doesn't affect the connection.
In reply to steve:
Thanks for the reply. Can you guide me how to disband the group?
In reply to DSELVAK9:
Make sure you are in Placement Application Mode (Setup - Application Mode - Placement Edit) then hover over the parts (use the tab to cycle what you have selected until the whole module is highlighted, then RMB (right mouse button) Disband group....