Hi all, I want to learn to generate output files (gerber, nc drill, etc) so that my board can be manufactured. I don't know from where to start. Is there any tutorial about generating output files for Allegro 15.2? And how to check if the output files are correct? Thanks.
There is documentation within the Allegro environment that describes how to create artwork files and nc drill data. Look under the Allegro PCB Editor User Guide for the section "Preparing Manufacturing data". You will learn there that the artwork files can be imported back into Allegro for review. Hope this helps. Charlie
You may want to attend an EMA sponsered webinar on Feb 16; Preparing Design For Manufacturing. http://www.ema-eda.com/training/webinar.aspx
I would also like to learn about test preparation (testprep) beyond what the User Guide has to offer in the Preparing Manufacturing Data for Allegro 15.5 Thanks,
You should start a new topic for this discussion. What specifically do you want to know?