I have a code which print out a report file (ex: a.rpt) as below:
Via Start Layer Via End Layer Via LocationETCH/TOP ETCH/BOTTOM (5.5:42.5)ETCH/TOP ETCH/BOTTOM (5.5:40.5)ETCH/TOP ETCH/BOTTOM (6.0:84.0)ETCH/TOP ETCH/BOTTOM (6.0:86.0)
I want to highlight location xy with one color and after I checked a location , it will change into one other color( at the same way dangling report check in allegro)
How can I do it?
In reply to Pawandeep:
In reply to luanvn81:
I think you want to put a permanent highlight color on certain vias, and after you have fixed each one, the program would change the color. In that way you could see the vias you have fixed.
Unfortunately Allegro doesn't let you put a permanent highlight on vias. I wish it did.
In reply to Geoff:
I think what Luan is asking is that if we run dangling line report from Tools->Reports->Dangling lines, we are able to zoom in the locations and the links(XY locations) that we clicked are highligted in a "Darker Tone" shade then the rest of Blue color locations as shown in my attached image.
Is there any way to achieve this for any custom reports generated using SKILL?
You are right, the problem is the lack of highlighting in a user report. I should have read Luan's post more closely.
I also would like to find out if it's possible to do.
See if this does what you want:
Go to Setup->User Preferences->Html and make sure the "Enable HTML" box is checked.
Then open your file using File->File Viewer.
In reply to Randy R:
Hi Randy & everyone !
Thank for yours advices. That really what I want, now it works as my expectations.Once again thank you very much.