Stats

Locked Locked
Replies 3
Subscribers 166
Views 14107
Members are here 0

Trying to use activeparts in Orcad.

When I to go to activeparts in orcad, Place parts - select ICA, the software goes to Cadence.com and not the ACTIVEPARTS screen. Am I doing something wrong ?

Liana over 9 years ago

I asked Cadence about this last week and was told they no longer offer this feature :( I hope if enough people request it they may bring it back...
Cancel
Vote Up 0 Vote Down

Cancel
djs42 over 9 years ago

I think Cadence has built upon this functionality and rolled it into CIP (not free).
Cancel
Vote Up 0 Vote Down

Cancel
steve over 9 years ago

The data on Active Parts was very dated so for now try looking at www.snapEDA.com or http://orcad.co.uk/images/PDF/Footprints.pdf which lists Manufacturers and tools that provide Cadence schematic symbols and PCB Footprints. Most are free some are paid for solutions.
Cancel
Vote Up 0 Vote Down

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.