Stats

  • Locked Locked
  • Replies 6
  • Subscribers 164
  • Views 15332
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Keepouts

TH Designs

I have a connector symbol that has two mounting holes. I want to have an area around the mounting holes where there can be no other components. On the bottom side there shall be no traces, but traces are allowed on the top side.

I have tried many different keepouts and the only errors I ever get are for vias or traces inside the keepout area. I can put a component in there and don't get any error.

I have tried:place outline, Route Keepout, Package keepout, all will allow me to place a part within the keepout area.

Suggestions?

Tom

Parents
  • TH Designs

    Thanks for the offer, but NDA in place with customer so can't send any board files.

    Tom

Reply
  • TH Designs

    Thanks for the offer, but NDA in place with customer so can't send any board files.

    Tom

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.