Stats

  • Locked Locked
  • Replies 8
  • Subscribers 164
  • Views 17624
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to check the unconnected line in Concept HDL

archive

I met an problem in Concept HDL. 
Concept HDL can't  check unconnected line during drawing schematic.

It like below:

A line is close to one pin or other line, which should be connected.
Sometimes, it is hard to be discovered, and the Check Tools can't support it.
How check it?


Originally posted in cdnusers.org by leonlee
  • archive

    I have checked all the settings in Tools>Options/Check, no function for this check point.
    Does anybody meet the same problem?


    Originally posted in cdnusers.org by leonlee
  • archive


    Hi,

    We also sometimes face this problem in Design Entry CIS .And yes, it is hard to discover this in Design Entry CIS too. We discover this problem, when we donot a net in the PCB Editor after generating netlist . If there is a solution for checking this Design Entry CIS also ?

    Regards,
    Prajakta.


    Originally posted in cdnusers.org by psj
  • archive

    No any answer?

    UP~~~


    Originally posted in cdnusers.org by leonlee
  • archive

    Up to top.


    Originally posted in cdnusers.org by leonlee
  • anucheruvx
    in reply to archive

    Hi,

    I also met with the same problem, the tools/check don't recgnize it. How to solve it?

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.