Physical System Simulation

CDNS Forum Physical Categories

Actran

Adams

CAEFatigue

Computational Fluid Dynamics

Cradle CFD

Digimat

Dytran

Easy 5

Elements

FTI FormingSuite

Marc

MaterialCenter

MSC Apex

MSC Apex Generative Design

MSC CoSim

MSC Nastran

ODYSSEE

Patran

Romax

SimManager

Simufact

Virtual Test Drive

Physical System Simulation

Latest Posts

Not Answered

How do I enable HDF5 output in Marc?

Category: Marc

By blaeiouk
•
updated over 6 years ago by blaeiouk

2 replies • 16 views
Not Answered

missing slash entities while reading a list of file name

Category: Adams

By bsreevar
•
updated over 6 years ago by Jesper Slattengren

2 replies • 10 views
Not Answered

Can I install helium server manager on Linux openSUSE 13.1

Category: Adams

By romulus.crisan
•
updated over 6 years ago by jozef.bucha

1 replies • 8 views
Not Answered

pausing a nastran sol 101 run to interface an external code.

Category: MSC Nastran

By nlgyro
•
updated over 6 years ago by Don.Graff

1 replies • 9 views
Not Answered

Error extracting the mass, stiffness and structural damping matrices from a .bdf file

Category: MSC Nastran

By kenny.fernando.conto
•
updated over 6 years ago by Don.Graff

1 replies • 8 views
Not Answered

Error in "Renunber Entities" and amount of nodes

Category: MSC Apex

By kenny.fernando.conto
•
updated over 6 years ago by kenny.fernando.conto

3 replies • 9 views
Not Answered

Timing belt will "break" with a pretension of 3000 N

Category: Adams

By felixkonstantin.schymski
•
updated over 6 years ago by Jesper Slattengren

1 replies • 5 views
Not Answered

I have a modal analysis of a large system that I need to stop temporarily while higher priority analysis jobs can be run. Aside from a restart are there any options in "pausing" an analysis?

Category: MSC Nastran

By derek.lewis
•
updated over 6 years ago by derek.lewis

2 replies • 16 views
Not Answered

Wrong pdf in simcopmanion

Category: Adams

By jozef.bucha
•
updated over 6 years ago by SC202511202828

3 replies • 16 views
Not Answered

Hello, is there a way to use Linear spline instead of AKIMA or CUBIC splines because whenever i use linear spline with 5 data points ADAMS converted this data by doing extrapolation.

Category: Adams

By radhakrishnaiah.bathina
•
updated over 6 years ago by radhakrishnaiah.bathina

2 replies • 18 views

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.