Physical System Simulation

CDNS Forum Physical Categories

Actran

Adams

CAEFatigue

Computational Fluid Dynamics

Cradle CFD

Digimat

Dytran

Easy 5

Elements

FTI FormingSuite

Marc

MaterialCenter

MSC Apex

MSC Apex Generative Design

MSC CoSim

MSC Nastran

ODYSSEE

Patran

Romax

SimManager

Simufact

Virtual Test Drive

Physical System Simulation

Latest Posts

Not Answered

How can I pass simulation run time(s) to a script from a design variable variable?

Category: Adams

By Todd Gatman
•
updated over 7 years ago by Todd Gatman

11 replies • 135 views
Not Answered

Imprint mesh on surface so that I can use the same mesh (as my starting point) for my new mesh on the adjacent part

Category: Patran

By shaheer.iqbal
•
updated over 7 years ago by edwin.goei

3 replies • 35 views
Not Answered

How do i provide table data from a 2D model and convert that table for a 3D model ?this model is a rubber bushing.(2D-axisymmetric to 3D)

Category: Marc

By Chirag
•
updated over 7 years ago by Chirag

2 replies • 12 views
Not Answered

An internal error in patran2019 when OP2 file is attached

Category: Patran

By kameya
•
updated over 7 years ago by kameya

2 replies • 23 views
Not Answered

Damping in progressive failure simulation

Category: Marc

By borys
•
updated over 7 years ago by zhong.qin

2 replies • 29 views
Not Answered

How to measure and minimize RMS error between model predicted results and imported test data (when using DOE)?

Category: Adams

By Jaco
•
updated over 7 years ago by Jaco

2 replies • 27 views
Not Answered

SYSTEM WARNING MESSAGE 6065 (DBC); Tech Articles ID KB8019399 Reference Question and MSC's answer below in "Details" My follow-up question: What is the recommended avoidance if Nastran DBCFACT = 4 is already being used?

Category: MSC Nastran

By dmcsorle
•
updated over 7 years ago by Don.Graff

5 replies • 22 views
Not Answered

Not getting stress output for composite layers with MSC-Nastran solution 103 for shock spectrum analysis or Sol 111 for random vibration analysis. How can I get the stress output for individual layers with these solution types?

Category: Patran

By MBowitz
•
updated over 7 years ago by Hrishikesh Phadke

2 replies • 17 views
Not Answered

ADAMS/Verification Guide: Problem 2.5.

Category: Adams

By junfen.shi
•
updated over 7 years ago by junfen.shi

4 replies • 37 views
Not Answered

Required cards for SOL 109 and SOL 112 with Acceleration as input using SPCD

Category: MSC Nastran

By Amit
•
updated over 7 years ago by Amit

3 replies • 19 views

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.