Physical System Simulation

CDNS Forum Physical Categories

Actran

Adams

CAEFatigue

Computational Fluid Dynamics

Cradle CFD

Digimat

Dytran

Easy 5

Elements

FTI FormingSuite

Marc

MaterialCenter

MSC Apex

MSC Apex Generative Design

MSC CoSim

MSC Nastran

ODYSSEE

Patran

Romax

SimManager

Simufact

Virtual Test Drive

Physical System Simulation

Latest Posts

Not Answered

What's New in Utilities for Patran 2018

Category: Patran

By Darrel Sinclair
•
updated over 8 years ago by Arthur Hickson

1 replies • 18 views
Not Answered

SPC on rotational DOF in axisymmetric analysis

Category: Marc

By espen.myklebust
•
updated over 8 years ago by espen.myklebust

2 replies • 40 views
Not Answered

Modeling a bearing with Sol 101 and linear contacts.

Category: Patran

By ron.kunz
•
updated over 8 years ago by ron.kunz

2 replies • 21 views
Not Answered

Couple/Connect two RBE2`s. Connecting the independent nodes.

Category: Patran

By ron.kunz
•
updated over 8 years ago by ron.kunz

2 replies • 32 views
Not Answered

When creating MNF for Adams using PATRAN, I can't seem to find consistent information on number of modes to request in the Adams prep form and in the subcase parameter output roots form to get correct modes output.

Category: Adams

By jesse.d.davis.ctr
•
updated over 8 years ago by Maziar R

1 replies • 21 views
Not Answered

Could you tell me the ratio of Kinematic Hardening and Isotropic Hardening if I select Combined Hardening in Materials Properties? And if it is possible to set the ratio of Kinematic Hardening, how can I do it?

Category: Patran

By kim_jinwoo
•
updated over 8 years ago by Sanjay Patel

1 replies • 14 views
Not Answered

What causes a shadow supervisor surface error?

Category: Patran

By tastypastry
•
updated over 8 years ago by edwin.goei

1 replies • 8 views
Not Answered

Ths2Txt.exe not printing out all elements?

Category: Dytran

By rhys.parsons
•
updated over 8 years ago by joe.satkunananthan

2 replies • 53 views
Not Answered

elementnumber

Category: Marc

By Kuniharuukuni
•
updated over 8 years ago by joe.satkunananthan

1 replies • 12 views
Not Answered

How to develop ply layups for a conical surfaces?

Category: Patran

By vishal.m
•
updated over 8 years ago by bhoomi.gadhia

1 replies • 20 views

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.