Physical System Simulation

CDNS Forum Physical Categories

Actran

Adams

CAEFatigue

Computational Fluid Dynamics

Cradle CFD

Digimat

Dytran

Easy 5

Elements

FTI FormingSuite

Marc

MaterialCenter

MSC Apex

MSC Apex Generative Design

MSC CoSim

MSC Nastran

ODYSSEE

Patran

Romax

SimManager

Simufact

Virtual Test Drive

Physical System Simulation

Latest Posts

Not Answered

What is Part Reduction Under Simulation Settings?

Category: MSC Apex

By blaeiouk
•
updated over 8 years ago by blaeiouk

2 replies • 13 views
Not Answered

Calculated inertia... with respect to which point?

Category: Adams

By leroy.deruijsscher
•
updated over 8 years ago by Jesper Slattengren

1 replies • 17 views
Not Answered

Why am I getting wrong SOL200 gradients with increasing numbers of variables?

Category: MSC Nastran

By olivia.stodieck
•
updated over 8 years ago by olivia.stodieck

5 replies • 60 views
Answered

Is there a way to use an arbitrary increment of one load case, as the starting point of another loadcase. When I try restarting using a t08 file from the middle of a load case, Marc will just continue that load case instead of starting the new load case.

Category: Marc

By espen.myklebust
•
updated over 8 years ago by espen.myklebust

2 replies • 35 views
Not Answered

How to run several Marc jobs in a batch mode?

Category: Marc

By thomas.halama
•
updated over 8 years ago by thomas.halama

2 replies • 43 views
Not Answered

I put in the card - PARAM,NOCOMPS=-1 to a working deck and got the 0*** SYSTEM FATAL MESSAGE 1030 (XIO) BLOCK NUMBER MISMATCH IN READ 0********* DUMP OF XIO PARAMETERS Does anyone know what could be causing this. Thanks

Category: MSC Nastran

By i.kelly
•
updated over 8 years ago by i.kelly

2 replies • 24 views
Not Answered

Node merging on different mesh bodies

Category: MSC Apex

By levente.szalontai
•
updated over 8 years ago by levente.szalontai

5 replies • 65 views
Not Answered

How to give static toe and static camber

Category: Adams

By Sudeep Tyagi
•
updated over 8 years ago by greg.wheeler

4 replies • 56 views
Not Answered

I am getting an error on Dytran relating to converting a token in to an integer, for a SET1 used in a contact. Are there any quick debugs I could try?

Category: Dytran

By rhys.parsons
•
updated over 8 years ago by rhys.parsons

5 replies • 85 views
Answered

Could you tell me the ratio of Kinematic Hardening and Isotropic Hardening if I select Combined Hardening in Materials Properties? And if it is possible to set the ratio of Kinematic Hardening, how can I do it?

Category: MSC Nastran

By kim_jinwoo
•
updated over 8 years ago by Don.Graff

2 replies • 32 views

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.