Stats

Locked Locked
Replies 2
Subscribers 143
Views 1977
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

dbGetTrueOverlaps issue - Very important

SUBBHAREDDY over 16 years ago

Hi Guys

The below function checks only for overlapping of wires and not any other pins.

This gives i.d if it is overlapping with wire,but not any other pins and transistors.

How to overcome this issue ?

connWire = dbGetTrueOverlaps( cv list(7.94375:-2.6 8.44375:-2.6 ) list("wire" "drawing") 0:0 )

I checked it practically in schematic window.

How to overcome it,Pls help me to resolve this issue ?

Thanks and regards

Subbhareddy

Parents

SUBBHAREDDY over 16 years ago

Thanks
It works fine.

Thanks and regards
Subbhareddy
Extn :3158
Cancel
Vote Up 0 Vote Down

Cancel

Reply

SUBBHAREDDY over 16 years ago

Thanks
It works fine.

Thanks and regards
Subbhareddy
Extn :3158
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.