Stats

Locked Locked
Replies 7
Subscribers 143
Views 16026
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Config View Creation

Dear All,

I am totally new in SKILL coding. I want to create automatic schematic from verilog view and then creating "config" view from the schematic view. And then I want to create netlist from the "config" view.

I have created the schematic view successfully. Can you please help for the next two steps? Especially the creation of config view !!!

Thanks to all of you in advance for your suggestions...

Parents

mobileee over 16 years ago

Hi Andrew,

Where can I find the solutions? I have logged into Sourcelink but unable to find the solution. Please help.

I want to create netlist from the config view to simulate into the spctreVerilog Simulator.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

mobileee over 16 years ago

Hi Andrew,

Where can I find the solutions? I have logged into Sourcelink but unable to find the solution. Please help.

I want to create netlist from the config view to simulate into the spctreVerilog Simulator.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.