Stats

  • Locked Locked
  • Replies 8
  • Subscribers 143
  • Views 18706
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

A question about setting grid controls...?

IC Layout
Hi! I have a small question about setting grid controls in layout editor... I would like to set grid value 10nm... Are the below lines can set grid for 10nm minor spacing = 0.01 major spacing = 0.01 X Snap Spacing = 0.005 Y Snap Spacing = 0.005 or shall I need to fill above four fields with 0.01 Which will essentially decides the grid value for the layout editor... Thanks in Advance... Prabhakar. K -- Layout Engineer
Parents

  • Henry,

    After you emailed this to me directly, I suggested you log a service request via http://support.cadence.com . Not sure why you didn't do that, since that's what customer support is for? By all means somebody may be able to help you here (won't be me, because I'm overloaded at the moment), but if you go to customer support there is a dedicated support team.

    Regards,

    Andrew.

Reply

  • Henry,

    After you emailed this to me directly, I suggested you log a service request via http://support.cadence.com . Not sure why you didn't do that, since that's what customer support is for? By all means somebody may be able to help you here (won't be me, because I'm overloaded at the moment), but if you go to customer support there is a dedicated support team.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.