Stats

Locked Locked
Replies 9
Subscribers 143
Views 16110
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using ocnxlRun in a loop

I am trying to run multiple ADE XL runs from an ocean script, but each time I run simulations using the ocnxlRun command the script waits until that job is finished. Is there any way to setup the ocnxljob such that it doesn't wait on previous runs to finish before starting the next jobs?

Thanks

Parents

webbyguy over 14 years ago

Thanks guys. We are downloading 6.1.5, and we will try it soon. We also look forward to the ability to run the ocnxlRun command in a non blocking mode.

John
Cancel
Vote Up 0 Vote Down

Cancel

Reply

webbyguy over 14 years ago

Thanks guys. We are downloading 6.1.5, and we will try it soon. We also look forward to the ability to run the ocnxlRun command in a non blocking mode.

John
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.