Stats

  • Locked Locked
  • Replies 15
  • Subscribers 144
  • Views 6186
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

command "sevRun" or "sevRunEngine"

imagesensor123

 Hi,

    i know that if you start analogArtist from schematic composer, the current schematic will be loaded as the current design in analogArtist, and I noticed that the analog-Artist use the command "sevRun" or "serRunEngine" to start a simulation,  and i am trying my own simulation method, like the "paramAnalysis", but  i found that when i put the sevRunEngine in my own procedure, it always prompts that "Need to select design before issuing this command" in CIW, and then i used the command "sevChooseDesign()", but this can't work well either. so here i want to make sure two points:

 1,  how to apply sevRun or sevRunEngine correctly, what's the necessary condition, such as a design?

 2,  for one thousand(this is a random value which depend on the input matrix) times parameter simulation, especially for only one parameter, what is the best way? i intend to use a loop in skill function "myOwnSim()", and in this function, i can calculate some equations. i think this way is more convenient than paramAnalysis

 welcome to any discussions,

Regards,

zfeng

Parents
  • tyanata

     Hello,

    The problem is that i do not want to set this option in .cdsenv file because, in that way it will be applicable for all started simulations. But I do not want to disturb the normal work of the original simulation buttons. 

    Little bit more info about this option: setting this option simulation will stop after netlisting ( if Netlist and Run is called) and in the output file the number of token licenses is outputed. So if I enter this option in .cdsenv file, no simulation can be run.

     

     In the topic which you mention there is some proposal for your question:

    asiSetEnvOptionVal( asiGetCurrentSession( ) 'switchViewList '("spectre" "schematic" "veriloga") ) 

     

    May be some thing similar must be entered in my SKILL procedure.

     

    Best regards,

     

    tyanata

     

Reply
  • tyanata

     Hello,

    The problem is that i do not want to set this option in .cdsenv file because, in that way it will be applicable for all started simulations. But I do not want to disturb the normal work of the original simulation buttons. 

    Little bit more info about this option: setting this option simulation will stop after netlisting ( if Netlist and Run is called) and in the output file the number of token licenses is outputed. So if I enter this option in .cdsenv file, no simulation can be run.

     

     In the topic which you mention there is some proposal for your question:

    asiSetEnvOptionVal( asiGetCurrentSession( ) 'switchViewList '("spectre" "schematic" "veriloga") ) 

     

    May be some thing similar must be entered in my SKILL procedure.

     

    Best regards,

     

    tyanata

     

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.