Stats

  • Locked Locked
  • Replies 4
  • Subscribers 143
  • Views 14642
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

problem with viewing schematic

Aritra
Hi ,

 I am using IC 6.1.3 . I am facing some problem with viewing the schematic. When I am making some layers in the LSW visible only, the schematic is not visible. Say I am making visible only metal1 . At this time if I open the schematic it will not show anything.

But If I make all layer visible then I can view the schematic fine. Is it possible to make the schematic view independent of the schematic ?

 I also have all set all layer valid form LSW. May I need to change some layer to non-valid?
Parents
  • dmay

    This is the bindkey we use. It basically makes all of the system layers visible.

     foreach( l setof(lyr techGetTechFile(geGetEditCellView())~>lps  (lyr~>number >= 207) ) l~>visible = t) hiRedraw()

    Derek

Reply
  • dmay

    This is the bindkey we use. It basically makes all of the system layers visible.

     foreach( l setof(lyr techGetTechFile(geGetEditCellView())~>lps  (lyr~>number >= 207) ) l~>visible = t) hiRedraw()

    Derek

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.