Stats

  • Locked Locked
  • Replies 1
  • Subscribers 144
  • Views 13172
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Skill code to create bus without using MPP.

deepak1947
Hello Guys, Can we create a bus without MPP technique?. Also do we have a skill code to continue such bus.
Parents
  • Austin CAD Guy

     Check out the bus creation in turbo toolbox. It creates the bus segments by offseting the new shapes from the centerline of the original shape then uses the new shape to create the new shape.

    The offset is

    .5 * (width_originalPath + width_newPath) + spacing

    If a segment gets too short  the paths will wrap around.

     

    Ted

Reply
  • Austin CAD Guy

     Check out the bus creation in turbo toolbox. It creates the bus segments by offseting the new shapes from the centerline of the original shape then uses the new shape to create the new shape.

    The offset is

    .5 * (width_originalPath + width_newPath) + spacing

    If a segment gets too short  the paths will wrap around.

     

    Ted

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.