Stats

  • Locked Locked
  • Replies 3
  • Subscribers 143
  • Views 1002
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

run() & monteRun()

imagesensor123

 Hi all,

     for the same simulation, i have two process. the first, i set my model to the mc section, and i launched a simulation by clicking the "netlist and run" icon, we can get the result1(output curves). the second i also started a simulation from tools->monte Carlo, after configure the form, i triggered the "run" from the analog statistical analysis menus. we will get another result2. in special case, if i set the startIter "1" and numIter "1", can we espect that the result2 is the same with the result1? in another word, we choose "mc" section , not "tm" section in a classic simulation( from ADE window directly), is it a monte carlo analysis (just for one time)? one more question, could we change distribution method during monte carlo analysis? i didn't find any entrance in the analog statistical form.

 welcome to any discussion!

regards,

zfeng

Parents

  •  Hi Andrew,

          yes, i agree with you. as we know, the montecarlo analysis use some random values controled by distribution method, and what i puzzled about is that if we can change only the model section to perform a monte-carlo analysis? that means i do not trigger the simulation from tools->montecarlo->simulatio->run, just from the ADE main window. if not, what's the difference between the normal simulation(section tc) and this one (section mc)? by the way, i do use IC5141. thanks a lot.

    regards,

    zhenfu

Reply

  •  Hi Andrew,

          yes, i agree with you. as we know, the montecarlo analysis use some random values controled by distribution method, and what i puzzled about is that if we can change only the model section to perform a monte-carlo analysis? that means i do not trigger the simulation from tools->montecarlo->simulatio->run, just from the ADE main window. if not, what's the difference between the normal simulation(section tc) and this one (section mc)? by the way, i do use IC5141. thanks a lot.

    regards,

    zhenfu

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.