Stats

  • Locked Locked
  • Replies 8
  • Subscribers 143
  • Views 14448
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ocean run corner on the termination of an error is encountered!!!!

xianweng

hello,

Run with the ocean corner, write the results in txt, the error is encountered in some corner on the next stop, and how to display an error and then continue to run forever? Just use soon, thank you advice 

for example:

if I want to seek GB, GAIN
PM = phaseMargin (VF ("/ V"))
GB = gainProd (VF ("/ V"))
GAIN = value(dB20(VF("/V")) 1)
if(PM&&GB&&GAIN fprintf(p, "%f %f %f \n"  PM GB GAIN) fprintf(p, "%s\n" "error"))
It is an error "Gain dose not cross one" when i run ocean,then  the simulation stops, but when I comment GB GAIN ,It is still an error "Gain dose not cross one", but the simulation can continue

How to make the simulation continue with errors

Parents
  • It's probably due to something failing in your fprintf after the run() command. Most likely, the results are not present, and so any results access you're doing is returning nil, resulting in an error in either a calculation or in the expected type in the arguments to printf.

    I normally recommend using constructs like:

    when(member('dcOp results())
    ; do calculations and fprintf
    )

    The first argument to member might be 'tran or whatever analysis you're trying to get the results from - see what they're called by calling results() in a successful run.

    Regards,

    Andrew
Reply
  • It's probably due to something failing in your fprintf after the run() command. Most likely, the results are not present, and so any results access you're doing is returning nil, resulting in an error in either a calculation or in the expected type in the arguments to printf.

    I normally recommend using constructs like:

    when(member('dcOp results())
    ; do calculations and fprintf
    )

    The first argument to member might be 'tran or whatever analysis you're trying to get the results from - see what they're called by calling results() in a successful run.

    Regards,

    Andrew
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.