Stats

Locked Locked
Replies 3
Subscribers 143
Views 13465
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Round ruler!!

Hi,

Do we have Round ruler option in IC6.1.5?? If not can you please point me to the piece of code if you have.

Round ruler is good in cases where we route nets at the corner, where we get to measure spacing twice (One at the x axis and other in y axis)

Thanks,

Bharath.

Andrew Beckett over 13 years ago

Bharath,
I don't really understand what you mean. Maybe a picture would help?
Andrew
Cancel
Vote Up 0 Vote Down

Cancel
bharath006 over 13 years ago

Hi Andrew,
Please find the attached picture.
Regards,
Bharath
Cancel
Vote Up 0 Vote Down

Cancel
Andrew Beckett over 13 years ago

OK, so how did you create this before (was this in an older release)? I'm guessing it was some custom code - and in which case, you should be able to use that in IC615 too.
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.