Stats

Locked Locked
Replies 2
Subscribers 142
Views 14717
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Utility to convert Path to Path Seg

Paramjeet over 12 years ago

Hi,

I have a tool which only works on Path Segs.

Is there any skill code which can convert all the PATHS to PATHSEG.

I have created the signal using path command, whereas the tool which I have to work on requires the signal to be created using create wire command. Is it possible to change all the PATH

Thanks & Regards

Paramjeet Singh

Parents

Paramjeet over 12 years ago

Thanks a lot Andrew for your help.

It was really a helpful code.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Paramjeet over 12 years ago

Thanks a lot Andrew for your help.

It was really a helpful code.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.