Stats

Locked Locked
Replies 1
Subscribers 143
Views 694
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to get minimum two VIA's when using AutoVIA

I am using 614 version. Auto option in Create Via creates possible no. of VIA's when I click on two layers which need to be connected. If area of overlap of these two layers is very small then only one VIA is placed at that area. I would like to get minimum two VIA's at that overlap place. Please help me on this.

Thank you,

Sarvani

Parents

Andrew Beckett over 12 years ago

Sarvani,
Can you move to IC615? (IC614 is no longer supported). In IC615 there's an option on the auto-via form to specify the minimum number of cuts...
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 12 years ago

Sarvani,
Can you move to IC615? (IC614 is no longer supported). In IC615 there's an option on the auto-via form to specify the minimum number of cuts...
Regards,
Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.