Stats

  • Locked Locked
  • Replies 4
  • Subscribers 149
  • Views 17563
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Assigning net name to schematic symbol terminals

Eduard Raines

Hi,

Is it possible to assign net name to the symbol term in the schematic through skill without creating wire(wire stub) from the terminal?

Thanks,

Eduard Raines

Parents
  • Andrew Beckett

    Hi Eduard,

    Yes, you can do this with dbCreateInstTerm. However, if this is a normal schematic, the information will get lost if you open the schematic and do a check-and-save (or call schCheck from SKILL). So if you want it to be a human-editable schematic, you need to follow the schematic editor's semantics.

    Regards,

    Andrew.

Reply
  • Andrew Beckett

    Hi Eduard,

    Yes, you can do this with dbCreateInstTerm. However, if this is a normal schematic, the information will get lost if you open the schematic and do a check-and-save (or call schCheck from SKILL). So if you want it to be a human-editable schematic, you need to follow the schematic editor's semantics.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.