Hello,I want to create a new schematic from the library which is created by me. I put an instance from this library to the new schematic. I want to change pin names of this instance. The problem is that some pin names have a bus notation ( Ex: A<3:0>) and i want to change width of this pin (Ex: A<5:0>). Cadence document says width of pin cannot change by " myInst~>pin~>term~>numBits". Is there any way to do this?
A bit of a late reply - I'm still not really sure what you're doing. You normally would need to set the pin (or terminal) names on the symbol and then instantiate it and connect it up - even if doing it programmatically.