Stats

  • Locked Locked
  • Replies 7
  • Subscribers 144
  • Views 17452
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Symbol Creation for the entire library

kenambo

Hi all

I want to create symbols for all the schematics in a library. i know how to create a symbol for a cellview.

I dont know how to get schematics oneby one from a library and converts schematics into symbol.

Please give me some suggestions or ideas.

Thanks

Parents

  • Ted,

    Opening a cellView doesn't keep the file handle open, so it wouldn't run out of file descriptors. However, it does mean that you are keeping them all in memory - so it's always a good idea to close anything you open to allow it to purge anything no longer needed.

    Regards,

    Andrew.

Reply

  • Ted,

    Opening a cellView doesn't keep the file handle open, so it wouldn't run out of file descriptors. However, it does mean that you are keeping them all in memory - so it's always a good idea to close anything you open to allow it to purge anything no longer needed.

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.